Genuine-style high-pressure diesel fuel filter (WG9716550107) for SINOTRUK HOWO A7, T7H, T5G trucks — protects common rail system with fine filtration.
WG9716550107 High Pressure Fuel Filter for SINOTRUK HOWO Trucks – Precision Filtration for Diesel Engines
Protect your SINOTRUK HOWO’s fuel injection system with this high-performance High Pressure Fuel Filter (Parte No. WG9716550107) — engineered as a direct OEM replacement for models including A7, T7H, T5G, L9H, and other variants powered by WD615, MC07, MC11, and MC13 series diesel engines.
Especificaciones técnicas:
- Número de parte: WG9716550107
- Función: High-Pressure Diesel Fuel Filter
- Fitment: SINOTRUK HOWO A7 / T7H / T5G / L9H
- Engine Compatibility: WD615, MC07, MC11, MC13
- Eficiencia de filtración: 99% @ 3–5 microns (ISO 19438 obediente)
- Presión de funcionamiento: Arriba a 1,800 bar (intermittent)
- Material: Reinforced composite housing + stainless steel fittings
- Seal Type: Nitrile rubber O-ring (fuel resistant)
- Service Interval: 20,000–30,000 km (depending on fuel quality)
1. TRATAMOS A CADA CLIENTE COMO NUESTRO AMIGO, PEGARSE AL PRINCIPIO: BENEFICIO MUTUO Y GANADOR ;
2. UNA VARIEDAD DE ELECCIÓN DE PRODUCTOS: CALIDAD, MARCA, EMBALAJE;
3. LE RESPONDEREMOS SU CONSULTA EN 24 HORAS.
4.Proveedor de piezas de rendimiento profesional SINOTRUCK
5. ESTAREMOS EN SERVICIO 24/24 HORAS DEL DÍA LABORAL.
6. CULO: LE OFRECEMOS EL MEJOR SERVICIO POSTVENTA.
Notas de instalación:
Turn off the engine and relieve fuel system pressure before starting work.
Locate the high-pressure fuel filter housing on the engine side or near the fuel pump.
Use clean rags and safety gloves; disconnect inlet and outlet fuel lines using appropriate line wrenches.
Remove mounting bolt(s) securing the old WG9716550107 filter.
Drain residual fuel into a proper container.
Lubricate the new filter’s O-ring lightly with clean diesel or engine oil.
Install the new filter and hand-tighten — follow torque specs (typically 25–30 Nm).
Bleed air from the fuel system using the manual priming pump or electric primer.
Start the engine and check for leaks at connections under running conditions.
